Entropy in everyday life

Discussion in 'General Philosophy' started by wegs, May 20, 2019.

  1. wegs Matter and Pixie Dust Valued Senior Member

    Messages:
    9,253

    Please Register or Log in to view the hidden image!



    Okay, so entropy is basically:

    The amount of disorder in a system and the amount of unavailable energy in a system.

    And, I'm assuming this is always the case in a closed system.



    Please Register or Log in to view the hidden image!

     
    Last edited: May 21, 2019
  2. Google AdSense Guest Advertisement



    to hide all adverts.
  3. Michael 345 New year. PRESENT is 72 years oldl Valued Senior Member

    Messages:
    13,077
    No unit of aging

    Change occurs in everything which exists

    Something does not change, it does not age

    Change can be as small as you mentioned the vibrations of a objects atoms or a rocket going into orbit

    Where incidentally it ages less because it's speed is greater

    What is the mechanism by which it acts upon things to increase entropy?

    Existence could be said to be the mechanism ie stuff which exists has its own built in mechanism (vibration of its atoms)

    Very strange - stuff which does not exist does not age

    How about that

    Please Register or Log in to view the hidden image!



    Please Register or Log in to view the hidden image!

     
  4. Google AdSense Guest Advertisement



    to hide all adverts.
  5. DaveC426913 Valued Senior Member

    Messages:
    18,935
    Perfect. It can't be measured. So it's philosophy, not science.

    Existence is not a mechanism. Vibration of atoms doesn't make things age.

    You're beginning to sound like River.
     
  6. Google AdSense Guest Advertisement



    to hide all adverts.
  7. Michael 345 New year. PRESENT is 72 years oldl Valued Senior Member

    Messages:
    13,077
    No units of AGE

    But arbitrary measurements have been given various arbitrary names

    This is 1 second old

    This is 4 years old

    Not science, not philosophy

    The vibrations change the brick and

    disintegrate - change

    Could be - he might have me on Iggy if he thinks I post stupidity

    Please Register or Log in to view the hidden image!



    Please Register or Log in to view the hidden image!

     
  8. exchemist Valued Senior Member

    Messages:
    12,452
    The other name for this is "waste heat". It is essential to understanding the efficiency of any heat engine, such as in a car or a power station. All our attempts to use energy with less waste need to be aware of the "waste heat" that is generated.

    The rule of thumb is that the higher the temperature of a given amount of heat, the more work it can do as its temperature falls. So for example a steam turbine's efficiency is improved if it runs on superheated steam rather than steam at the temperature at which it boils off. The formula for it is efficiency, η, = 1- T(out)/T(in), in which T in is the temperature of the heat going in (e.g. the superheated steam) and T out is the temperature of the exhaust steam on its way to the condenser. The efficiency is the ratio of work extracted to heat input.

    If you look at the formula, you can see you can only get 100% efficiency if either T out is absolute zero (impossible) or if T in is infinite (impossible). It is in practice a huge struggle to get η up to 50%, though some power stations can get a bit better. Basically you nearly always waste at least half the heat input - and often a lot more. A car engine does well to get better than 30% efficiency.
     
  9. wegs Matter and Pixie Dust Valued Senior Member

    Messages:
    9,253
    Ah! Gotcha, that makes sense.

    Okay, thanks. This might be a silly question, but why does a car ''over heat?'' When a car over heats, it ceases to operate efficiently, or at all.
     
  10. billvon Valued Senior Member

    Messages:
    21,635
    That's a bit different.

    90% of a car's waste heat goes out the tailpipe. The car takes (cool) air and gasoline in and exhausts (hot) exhaust. The cooler the exhaust is the more efficient the car is, but even the most efficient cars out there are only about 40% efficient, so that's a lot of heat.

    The remaining 10% goes towards heating up the exhaust system, the engine block, the manifold etc. There are also frictional losses that heat up bearings and gears. There are active systems (coolant and oil) that transfer that heat from the engine to the environment via the radiator. When that system can't get the heat out fast enough then the temperature keeps rising and eventually the car overheats.
     
  11. wegs Matter and Pixie Dust Valued Senior Member

    Messages:
    9,253
    Thanks for this - what do you mean, most efficient cars are only 40% efficient?

    I feel like I take science for granted.

    Please Register or Log in to view the hidden image!

     
  12. billvon Valued Senior Member

    Messages:
    21,635
    The most efficient engine on the market is in the Gen-IV Prius, and it converts about 40% of the energy in the gasoline into mechanical energy. It does this by doing a lot of tricks, the biggest one being the Atkinson cycle engine*.

    Most car engines are much lower than that, between 20 and 30%. The only other engines that are close to the Prius engine in efficiency are diesels.

    You can get much higher efficiencies in non-internal-combustion engines, of course - electric vehicles are 90%+ efficient.

    (Atkinson cycle engines are super efficient but can't be used in most cars since they can't really idle. Hybrids, of course, don't have to idle.)
     
  13. DaveC426913 Valued Senior Member

    Messages:
    18,935
    What is the baseline here (i.e. what is the 100% reference mark)? At 100% efficiency, the byproducts would be CO2 and water - and zero heat*. Is that right?

    *(which, of course, is impossible, even in principle, even with theoretically perfect recovery systems. After all, some energy goes into heat and energy of the air from the moving vehicle.)
     
  14. wegs Matter and Pixie Dust Valued Senior Member

    Messages:
    9,253
    Okay, interesting. So, I did a quick Google search and found --> "for an engine to be 100% efficient, there would need to be no friction, no heat, no pollution, no emissions, etc." So, basically an impossible engine to construct.

    So, it's depressing to learn this fact - my car's engine is only capable of 25% (?) efficiency.

    Please Register or Log in to view the hidden image!

     
    Last edited: May 21, 2019
  15. DaveC426913 Valued Senior Member

    Messages:
    18,935
    A fact that an alarming number of Perpetual Motion Machine inventor-wannabes are in denial about.
     
  16. wegs Matter and Pixie Dust Valued Senior Member

    Messages:
    9,253
    It's a hard fact to swallow, I gotta be honest.

    I'm going to visit with some friends over the weekend, and I'm going to see if they realize this. ''Did you know that....?''

    Please Register or Log in to view the hidden image!



    So, most cars are 75% inefficient. That's pathetic, when you think about it. I get the science behind it, but I don't know many industries manufacturing products that offer 25% efficiency. Hmm. They wouldn't be in business long.
     
  17. DaveC426913 Valued Senior Member

    Messages:
    18,935
    Name a product that gets 100% efficiency. Name a product that gets even 50% efficiency.

    I think, first, you'll have define "efficiency" for a given product.

    If we're talking anything that converts energy into work, you're going to have to come up with one that produces no heat. (Which, again, can't be done, even in principle, because work generates heat.)

    Please Register or Log in to view the hidden image!

     
  18. wegs Matter and Pixie Dust Valued Senior Member

    Messages:
    9,253
    I'm not asking for 100% - but 25%? lol

    I can't believe it. I did a quick Google search, and I can't find a product that operates at even 50% efficiency.

    Please Register or Log in to view the hidden image!


     
  19. wegs Matter and Pixie Dust Valued Senior Member

    Messages:
    9,253
    Wait, an electric car would be roughly 85-90% efficient.
     
  20. DaveC426913 Valued Senior Member

    Messages:
    18,935
    The batteries don't produce heat?
     
  21. Michael 345 New year. PRESENT is 72 years oldl Valued Senior Member

    Messages:
    13,077
    That might well be true

    But before you pop the champagne think about the efficiency of all of of the machinery and equipment and used to produce the electricity pumped into the car

    If you want to move a 10 lb package from X to Y it will take E energy

    That E might come from a few or many sources but it will always total exactly E

    Anything over E is the waste heat

    Please Register or Log in to view the hidden image!

     
  22. DaveC426913 Valued Senior Member

    Messages:
    18,935
    Then we're back to open versus closed systems.

    It is up to wegs to decide if the "system" includes anything more than just the car and charged battery. In which case, the manufacturing is irrelevant.
     
  23. wegs Matter and Pixie Dust Valued Senior Member

    Messages:
    9,253
    Electric cars generate next to no heat so...

    That's true. There may also be the problem of coal used for electricity to power the electric cars, so that's not exactly environmentally friendly. There's always a catch.

    Please Register or Log in to view the hidden image!

     

Share This Page